18
English
Connections
Connect the Stand Pole to the Stand Bracket.
Insert and tighten three large screws into the
three holes on the Stand Bracket as shown in the
illustration.
1.
2.
Straighten the speaker wire and route it through
the Stand Pole.
3.
Connect the Stand Pole to the Stand Neck and
Stand Base.
- Make sure all holes are properly connected,
if not, the stand will fall down.
4.
Connecting the Speakers
Installing the Speakers on the Tallboy Stand
* HT-C755W
* Front/Rear Speakers only
Insert and tighten three large screws into the
three holes on the bottom side of the stand-base
as shown in the illustration.
Connect the speaker wire to the speaker jack.
5.
6.
Fully insert the Stand Bracket into the speaker's
clasp to stand speaker.
Insert and tighten two small screws into the two
holes to connect them.
7.
8.
Stand Pole
Stand Bracket
1
2
3
Stand Pole
Stand Base
Stand Neck
4
5
6
7
8
HT-C750W-NO EUR_ENG-0420.indd 18
HT-C750W-NO EUR_ENG-0420.indd 18
2010-04-20 6:23:52
2010-04-20 6:23:52