20
English
Connections
NOTE
Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too close to
the product, some sound interruption may be heard due to interference.
If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment, or any other device that
uses the same frequency (2.4/5.8GHz) near the product, some sound interruption may be heard due to
interference.
The transmission distance from the product to the wireless receiver module is about 10m, but may vary depending
on your operating environment. If a steel-concrete wall or metallic wall is between the product and the wireless
receiver module, the system may not operate at all, because the radio wave cannot penetrate metal.
If the product doesn't make wireless connection, the product needs ID Setting between the product and wireless
receiver module. With the product turned off, press remote control's number buttons "0"
J
"1"
J
"3"
J
"5" and the
message "W INIT" will appear on the display.
With the wireless receiver module turned on, press "ID SET" button on the back of the wireless receiver module for
5 seconds.
CAUTION
Do not insert any other card except the provided TX card.
If a different TX card is used, the product may be damaged or the card may not be removed easily.
Do not insert the TX card upside down or in the reverse direction.
Insert the TX card when the product is turned off. Inserting the card when it is turned on may cause a problem.
If the TX Card is inserted and wireless receiver module setting is complete, sound is not output from the rear
Speaker connectors on the product.
The wireless receiver antenna is built into the wireless receiver module. Keep it away from water and moisture.
For optimal listening performance, make sure that the area around the wireless receiver module location is clear of
any obstructions.
If no sound is heard from the wireless receiver module, switch the mode to DVD 5.1 channel or Dolby
ProLogic II .
In 2-CH mode, no sound will be heard from the wireless receiver module.
Attaching the Toroidal Ferrite Core to the Power Cord of the Main Unit
If you attach a Toroidal ferrite core to the power cord of the man unit, it will help to
prevent RF interference from radio signals.
Pull the fi xing tab of the Toroidal ferrite core to open it.
Make a loop twice in the main unit power cord.
Attach the Toroidal ferrite core to the main unit power cord as the fi gure shows and press it until it clicks.
✎
!
1.
2.
3.
HT-C750W-NO EUR_ENG-0420.indd 20
HT-C750W-NO EUR_ENG-0420.indd 20
2010-04-20 6:23:57
2010-04-20 6:23:57
