18
- English
Settings
•
Before you begin, confirm that the product is
connected to your router with a network cable.
Automatic
To start the configuration process, follow these steps:
1.
In the Home menu, select
Settings
, and then
press the
E
button.
2.
Select
Network
, and then press the
E
button.
3.
Select
Wired Network Settings
, and then press
the
E
button.
The
Wired Network Settings
screen appears.
4.
Press the
+
button on the
Internet Protocol
Setup
menu.
Use
%
button to select
Auto
, and then press
the
E
button.
Settings
Display
Audio
Network
System
Language
Security
General
Support
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
Wired Network Settings
Internet Protocol Setup
: Auto
IP Address
:
Subnet Mask
:
Gateway :
DNS :
Auto
DNS Server
:
>
Move
"
Select
'
Return
5.
The Network function acquires and fills in the
values for
IP Address
,
Subnet Mask
, etc.,
automatically.
6.
After the Network function has acquired the
network values, press the
RETURN
button.
7.
Select
Network Test
, and then press
E
. The
home theater validates the network connection.
When it is done, press the
RETURN
button.
Manual
If you have a static IP address or the Automatic procedure
does not work, you’ll need to set the Network Settings
values manually. You can get the Network Settings from
your Internet Service Provider (ISP).
Settings
Display
Audio
Network
System
Language
Security
General
Support
0
0
0
0
255 255 255
0
0
0
0
0
0
0
0
0
Wired Network Settings
Internet Protocol Setup
: Manual
IP Address
:
Subnet Mask
:
Gateway :
DNS :
Manual
DNS Server
:
>
Move
"
Select
'
Return
1.
Follow the first four steps in the Automatic
procedure, but select
Manual
instead of Auto in
Step 4.
2.
Press the
▼
button to go to the first entry field (IP
Address).
3.
Use the number buttons on your remote to enter
numbers.
4.
When done with each field, use the ► button to
move successively to the next field.
You can also use the other arrow buttons to
move up, down, and back.
5.
Enter the
IP Address
,
Subnet Mask
, and
Gateway
values.
6.
Press the ▼ button to go to
DNS
.
7.
Press the ▼ button to go to the first DNS entry
field. Enter the numbers as above.
8.
Press the
RETURN
button on your remote.
9.
Select
Network Test
, and then press
E
.
When the test is completed, press the
RETURN
button to exit to the previous screen.
10.
Select
Network Status
, and then press
E
.
11.
The
Network Status
screen appears.
The product verifies the network connection and
then connects to the network. When it is done,
highlight
OK
, and then press
E
.
HT-H4500_30_ZC-0210.indd 18
HT-H4500_30_ZC-0210.indd 18
2014-02-12 3:46:20
2014-02-12 3:46:20
