9
-
English
Connections
Installing the Speakers on the Tallboy Stand
1.
Turn the Stand Base upside-down and connect
it to the Stand.
2.
Use the driver to fasten the screws (5x20) on
the 4 marked holes.
3.
Straighten the provided speaker cable and run it
through the center hole of the Stand Base.
Pull the cable out from the hole of the stand
pole.
4.
Connect the upper Speaker to the assembled
Stand.
5.
Insert a screw (5x15) and fasten it lockwise
through the hole on the rear of the speaker
using a screwdriver.
6.
Arrange the speaker cable along the groove on
the rear side of the stand pole.
7.
Connect the arranged speaker cables to the
port on the speaker’s rear side while matching
their colors.
8.
This is the appearance after the speaker is
installed.
Follow this steps to install other speaker.
Speaker Cable Connections
1.
Match each speaker cable bundle to the correct speaker by matching the colored band on each bundle to
the colored sticker on the bottom or back of each speaker.
2.
Connect the speaker wire plugs from each speaker to the back of the product by matching the colored
band on each cable to the colors of the speaker jacks. When connecting, make sure to match label color
on the back of speaker.
2
4
1
3
Stand Base
Stand
Speaker
Stand
5
7
6
8
HT-J5530K-ZP-0327.indd 9
HT-J5530K-ZP-0327.indd 9
2015-03-27 9:37:00
2015-03-27 9:37:00