ENG - 22
3.
Connect the Wireless Receiver Module to the two Surround Speakers.
•
The speaker cables are colour coded.
SURROUND-LEFT
ID SET
L
R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
POWER
ID SET
L
R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
SURROUND-RIGHT
SURROUND-LEFT
SURROUND-RIGHT
4.
Plug in the Wireless Receiver Module, and then check its standby status.
•
The LINK LED indicator (blue LED) on the Wireless Receiver Module should blink. If the LED
does not blink, press the
ID SET
button on the back of the Wireless Receiver Module with a pen
tip for 5~6 seconds until the LINK LED indicator blinks (in Blue). For more about the LED, please
refer to the SWA-9000S user manual.
ID SET
L
R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
POWER
POWER
ID SET
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
STANDBY
LINK
STANDBY
LINK
5 Sec
Blue
blinking
5.
Press and hold the
Up
button on the remote control or press the
ID SET
button on the bottom
panel for at least 5 seconds.
•
The
ID SET
message appears on the display of the Soundbar for a moment, and then disappears.
•
The Soundbar will automatically power on when
ID SET
is complete.
ID SET
SOUN
D
MOD
E
PAIR
5 Sec
Summary of Contents for HW-NW700
Page 37: ...ENG 37 A B C D A B C D A B C D 4...
Page 38: ...ENG 38 5 CAUTION E F G H 6 7 8...
