ENG - 16
Manually connecting the Subwoofer or Surround Speakers
Before performing the manual connection procedure below:
• Check whether the power cables for the Soundbar and subwoofer or Surround Speakers are connected properly.
• Make sure that the Soundbar is turned off.
1.
Turn off the Soundbar main.
2.
Press and hold
ID SET
on the rear of the subwoofer and surround speakers for at least 5 seconds.
• The red indicator at the rear of each speaker turns off and the blue indicator blinks.
5 Sec
Blinking
blue fast
Rear of Subwoofer
Rear of Subwoofer
Blinking blue fast
POWER
x 2
Rear of the Left and Right Surround Speakers
(optional)
5 Sec
3.
Press the
Up
button on the remote control for 5 seconds.
• The
ID SET
message appears on the display of the Soundbar for a moment, and then it disappears.
• The Soundbar will automatically power on when
ID SET
is complete.
SOU
ND
MOD
E
PAIR
5 Sec
ID SET
4.
Check if the LINK LED is solid blue (connection complete).
LINK LED - Blue is On
(optional)
The LINK LED indicator stops blinking and glows a solid blue when a connection
is established between the Soundbar and the Wireless Subwoofer, surround
speakers.
