ENG - 29
2.
Align the
Wall Mount Guide’s Center Line
with the center of your TV (if you are
mounting the Soundbar below your TV), and
then fix the
Wall Mount Guide
to the wall
using tape.
• If you are not mounting below a TV, place
the
Center Line
in the center of the
installation area.
Center Line
3.
Push a pen tip or sharpened pencil tip
through the center of the
B-TYPE
images on
each end of the Guide to mark the holes for
the supporting screws, and then remove the
Wall Mount Guide
.
4.
Using an appropriately sized drill bit, drill a
hole in the wall at each marking.
• If the markings do not correspond to the
positions of studs, make sure you insert
appropriate anchors or mollies into the
holes before you insert the support
screws. If you use anchors or mollies,
make sure the holes you drill are large
enough for the anchors or mollies you
use.
5.
Push a screw (not supplied) through each
Holder-Screw
, and then screw each screw
firmly into a support screw hole.
6.
Use the two
Screws
(M4 x L12) to attach both
Bracket-Wall Mount L
and
R
to the
Soundbar’s bottom.
For a proper fit, make sure to align the
bumps on the Soundbar to the holes on the
brackets.
• When assembling, make sure the hanger
part of the
Bracket-Wall Mounts
are
located behind the rear of the Soundbar.
Rear of Soundbar
Right end of Soundbar
