ENG - 8
Manually connecting the Subwoofer if automatic connection fails
Before performing the manual connection procedure below:
• Check whether the power cables for the Soundbar and subwoofer are connected properly.
• Make sure that the Soundbar is turned on.
1.
Press and hold
ID SET
on the rear of the subwoofer for at least 5 seconds.
• The red indicator on the rear of the subwoofer turns off and the blue indicator blinks.
5 Sec
Rear of Subwoofer
2.
Press and hold the
Up
button on the remote control for at least 5 seconds.
• The
ID SET
message appears on the display of the Soundbar for a moment, and then it
disappears.
• The Soundbar will automatically power on when
ID SET
is complete.
SOUN
D
MOD
E
PAIR
5 Sec
ID SET
3.
Check if the LINK LED is solid blue (connection complete).
Blue is On
The LINK LED indicator stops blinking and
glows a solid blue when a connection is
established between the Soundbar and the
Wireless Subwoofer.