A-2
Appendix A
Troubleshooting
All LEDs on the side panel of the InfoRanger are
not turned on.
- Check to see if the power adapter is connected to the wall outlet
and DC input terminal of the InfoRanger.
- Check the wall outlet where the power adapter is connected.
- Check to see if the coaxial cable and Ethernet cable are not
connected to the Cable connector and Ethernet port properly.
PC LED is not turned on even though the cable is
connected to the Ethernet port or USB port.
- Check to see if the cable is connected properly to the Ethernet
interface card equipped in PC or the USB port of PC.
- Check the Ethernet interface card equipped in PC or USB port
of PC.
☞
Please refer to the manual of Ethernet interface card.
- Check to see if PC runs normally.
- Check to see if TCP/IP protocol is installed on PC.
- Check to see if the specification of RJ-45 Ethernet cable or USB
cable, which is used for connecting the Ethernet interface card
installed on PC or USB port of PC, is suitable.
☞
Please refer to Appendix D.
Cannot connect to the network after rebooting the
PC in Windows 2000 environment when using
Ethernet port of InfoRanger.
- Pull out the Ethernet cable from the Ethernet port of
InfoRanger and connect it again to get the new IP address.
Problem
Solution
Problem
Solution
Problem
Solution
Summary of Contents for InfoRanger SCM-140U
