QoS
You can specify the priority to secure a stable transfer rate for a specific IP.
1.
From the Setup menu, select the
<
network ( )
> tab.
2.
Click <
QoS
>.
3.
Click the [
add (
)
] button.
The IP list will be created.
4.
Enter an IP address to which you will
apply QoS.
M
`
The default prefix for IPv4 is 32;
For DSCP, the default is set to 63.
`
Only the IP addresses that are set to <
Use
> can be prioritized.
5.
Select an IP to delete from the list.
Click the [
Delete (
)
] button.
6.
When done, click [
apply (
)
].
Snmp
With the SNMP protocols, the system or network admin can monitor the network devices
on a remote site, and configure the environment settings.
1.
From the Setup menu, select the
<
network ( )
> tab.
2.
Click <
Snmp
>.
3.
Specify the <
Snmp
>.
•
Enable SNMP v1 : SNMP version 1
will be active.
•
Enable SNMP v2c : SNMP version
2 will be active.
- Read Community : Provide the
name of the read community where you can access to the SNMP information.
The default name is “pubic”.
- Write Community : Provide the name of the write community where you can
access to the SNMP information. The default name is “write”.
English
_65
●
Setup
Screen
