English -
listening through a receiver
You can listen to sound through a receiver instead of the tV speaker.
.
Press the
button.
Press the ▲ or ▼ button to select
receiver
, then press the
EntEr/oK
button.
.
Press the ◄ or ► button to select to
on
, then press the
EntEr/oK
button.
Now you can listen to sound through the receiver.
3.
Press the
Exit
button to exit.
When the receiver is set to On, you can listen to the TV sound
through the 2-channel receiver.
If the receiver is exclusively for a home theater only (supporting
audio only), it may not appear in the device list.
In case of a content with copyright problem, listening through the receiver may not properly operate.
When listening through the receiver, there are restrictions for using the PIP and audio-related menu.
➣
➣
➣
➣
Check Points before requesting Service
Symptom
Solution
does not
work.
■ Check if the device is an device. The system supports
devices only.
■ Connect only one receiver.
■ Check if the device power cord is properly connected.
■ Check the device’s Video/Audio/HDMI 1.3 cable connections.
■ Check whether (HDMI-CEC) is set to On in the setup menu.
■ Check whether the TV remote control is in TV mode.
■ Check whether it is exclusive remote control.
■ doesn’t work at a certain condition. (Searching channels)
■ When connecting or removing the HDMI 1.3 cable, please make sure to search
devices again or restart your TV.
■ Check if the Function of device is set on.
i want to start
.
■ Check if the device is properly connected to the TV and check if the
(HDMI-CEC) is set to On in the Setup menu.
■ Press the
tV
button on the TV remote control to switch to TV. Then press the
button to show the
menu and select a menu you want.
i want to exit .
■ Select
View tV
in menu.
■ Press the
SourCE
button on the TV remote control and select a device other
than devices.
■ Press any of
Ch
,
Ch liSt
,
PrE-Ch
, and such to change to the
TV mode. (Note that the channel button operates only when a tuner-embedded
device is not connected.)
the Connecting to
device…
message appears on
the screen.
■ You cannot use the remote control when you are configuring or
switching to a view mode.
■ Use the remote control when the setting or switching to view mode is
complete.
the device
does not play.
You cannot use the play function when Plug & Play is in progress.
the connected device
is not displayed.
■ Check whether or not the device supports functions.
■ Check whether or not the HDMI 1.3 cable is properly connected.
■ Check whether (HDMI-CEC) is set to On in the setup menu.
■ Search devices again.
■ You can connect an device using the HDMI 1.3 cable only. Some HDMI
cables may not support functions.
the tV program
cannot be recorded.
Check whether the antenna jack on the recording device is properly connected.
Enter
move
View tV
Select device
record
menu on device
device operation
receiver
:on
Setup
air 8
Exit
BN68-01199K-X0Eng-0424.indd 45
2007-04-27 ¿ÀÀü 10:38:03
