English-49
Setting Up the Remote to Operate Your DVD
1.
Turn off your DVD.
2.
Press the
DVD
button on your TV’s remote control.
3.
Press the
SET
button on your TV’s remote control.
4.
Using the number buttons on your remote control, enter three digits of the DVD code
listed on page 51~52 of this manual for your brand of DVD.
Make sure you enter three digits of the code, even if the first digit is a “0”.
(If there is more than one code listed, try the first one.)
5.
Press the
POWER
button on the remote control.
Your DVD should turn on if your remote is set up correctly.
If your DVD does not turn on after set up, repeat steps 2, 3, and 4, but try one of the other
codes listed for your brand of DVD.
If no other codes are list-ed, try each code, 000 through 141.
Note on Using Remote Control Modes: DVD
When your remote control is in “DVD” mode, the volume buttons still control your TV’s
volume.
Setting Up the Remote to Operate Your STB
1.
Turn off your STB.
2.
Press the
STB
button on your TV’s remote control.
3.
Press the
SET
button on your TV’s remote control.
4.
Using the number buttons on your remote control, enter three digits of the STB code
listed on page 52 of this manual for your brand of STB.
Make sure you enter three digits of the code, even if the first digit is a “0”.
(If there is more than one code listed, try the first one.)
5.
Press the
POWER
button on the remote control.
Your STB should turn on if your remote is set up correctly.
If your STB does not turn on after set-up, repeat steps 2, 3 and 4, but try one of the other
codes listed for your brand of STB.
(If no other codes are listed, try each code, 000 through 074.)
Note on Using Remote Control Modes: STB
When your remote control is in “STB” mode, the volume buttons still control your TV’s
volume.
BN68-01007N-00Eng.indd 49
BN68-01007N-00Eng.indd 49
2006-08-11
2:57:53
2006-08-11
2:57:53
