English-
31
O
P E R AT I O N
Setting Up the Remote to Operate Your .
Note on Using Remote Control Modes: DVD
When your remote control is in “DVD” mode, the volume buttons still control your TV’s volume.
1
Turn off your DVD.
2
Press the MODE button and make sure that the DVD
appears on the LCD screen.
3
Press the SET button on your TV’s remote control.
4
Using the number buttons on your remote control, enter three
digits of the DVD code listed on page 32 of this manual for
your brand of DVD. Make sure you enter three digits of the
code, even if the first digit is a “0”.
If there is more than one code listed, try the first one.
5
Press the Power button on the remote control. Your DVD
should turn on if your remote is set up correctly.
If your DVD does not turn on after set-up, repeat steps 2, 3 and
4, but try one of the other codes listed for your brand of DVD.
If no other codes are listed, try each code, 000 through 009.
Setting Up the Remote to Operate Your DVD
01 BN68-00910A-03Eng.qxd 10/20/05 3:29 PM Page 31
