- 12 -
Preparations
Installation
Attaching the Stand
"
Before assembling the product, place the product down on a flat and stable surface so that the screen is facing
downwards.
"
Disassembly is the reverse order of assembly.
x 2
1
1
2
4
3
Put the stand base onto the stand
neck as the direction shown in the
figure. Check that the stand neck is
firmly connected.
Tightly fasten the connecting
screw at the bottom of the stand
base. Fasten the large screw in the
middle for assembly.
As shown in the figure, remove
the product and foam cushion, and
then place the product on the table
with its front side facing the floor.
3
4
4
5
Push the assembled stand into the main body in the direction of the arrow
as shown in the figure. Tightly fasten the connecting screw at the bottom
of the main body.
Stand assembly is complete.
