English-
18
O
P E R AT I O N
Memorizing the Channels
Your TV can memorize and store all of the available channels for both “off-air” (antenna)
and cable channels. After the available channels are memorized, use the CH
and CH
buttons to scan through the channels. This eliminates the need to change channels by
entering the channel digits. There are three steps for memorizing channels: selecting a
broadcast source, memorizing the channels (automatic) and adding and deleting channels
(manual).
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the
type of signal source that is connected to the TV (i.e., an antenna or a cable system).
1
Press the
MENU
button
to display the menu.
Press the
UP/DOWN
buttons
to select “Channel”, then
press the
ENTER
button.
2
Repeatedly press the
ENTER
button to
cycle through these
choices:
Air (antenna), STD,
HRC or IRC (all cable
TV).
Press the
UP/DOWN
buttons to select the
Video signal source,
then press the
ENTER
button.
Note : STD, HRC and IRC identify various types of cable
TV systems. Contact your local cable company to identify
the type of cable system that exists in your particular area.
At this point the signal source has been selected.
Proceed to “Storing Channels in Memory” (next page).
victoryia 17-47 6/27/03 2:05 AM Page 18
