Samsung MAX-G55, User Manual

To take full advantage of your new mini-compact system, follow 
these installation instructions before connecting the unit.

Install the system on a flat, stable surface.
Never place this unit on carpeting.
Never place this unit in an outdoor area.
 Maintain an open space of approximately 6 inches (15 cm) on the 
sides and rear of the system, for ventilation purposes.
 Make sure that you have enough room to open the compact disc 
compartment easily.
 Place the loudspeakers at a reasonable distance on either side of the 
system to ensure good stereo sound.
Direct the loudspeakers towards the listening area.
 For optimum performance, make sure that both speakers are placed 
at an equal distance above the floor.

Where to Install Your Mini-Compact 
System

Connecting your System to the 
Power Supply

ENG

6

Insert or replace remote control batteries when you:

Purchase the mini-compact system
Find that the remote control is no longer operating correctly

 When replacing the batteries, use a new set of batteries and 
never mix alkaline and manganese batteries.

Place your thumb on the position marked        on the battery 
compartment cover (rear of the remote control) and pull the cover in 
the direction of the arrow.

Insert two AAA, LR03 or equivalent batteries, taking care to respect 

the polarities:

+ on the battery a in the battery compartment

– 

on the battery against – in the battery compartment

Replace the cover by sliding it back until it clicks into position.

◆

If you will not be using the remote control for a long time, 
remove the batteries to prevent corrosion.
The remote control can be used up to approximately 7 meters 

◆

in a  straight line. It can also be operated at a horizontal angle 
of up to 30° from the remote control sensor.

Inserting Remote Control Batteries

1

2

3

Before plugging your system into a main socket, you must check 
the voltage.

Plug the main lead into an appropriate socket.

Press the 

 (

STANDBY/ON) 

button to switch your mini-compact 

system .

1
2

The loudspeaker connector terminals are located on the rear 
of the system.

There are two terminals on the system:

left speaker (marked L)
right speaker (marked R)

To achieve the correct sound quality,insert those speaker connector 
cables to the speaker connector terminals of the system.

Connecting the Loudspeakers

L

R

FRONT

SPEAKERS OUT

IMPEDANCE 4

FRONT

R

L

MAX-G55

L

R

FRONT

FRONT

SUB WOOFER

SW

R

L

SPEAKERS OUT

IMPEDANCE 4

MAX-G56

MAX-G55-G56-NO ENG.indd   6

MAX-G55-G56-NO ENG.indd   6

2009-3-13   11:45:10

2009-3-13   11:45:10