GB
20
If the timer switch on and off times are identical, the word
ERROR
is
displayed.
The timer enables you to switch the system on or off at
specific times.
Example:
You wish to wake up to music every morning.
If you no longer want the system to be switched on or off
automatically, you must cancel the timer.
Before setting the timer, check that the current time is correct.
For each step, you have a few seconds to set the required
options. If you exceed this time, you must start again.
Switch the system on by pressing Standby/On.
Press Timer/Clock until
TIMER
is displayed.
Press Enter.
Result:
ON TIME
is displayed (instead of the equalizer symbols) for
a few seconds, followed by any switch-on time already set;
you can set the timer switch-on time.
Set the timer switch-on time.
a
Set the hour by tuning the Multi Jog knob to the right or to the left.
b Press Enter.
Result: The minutes flash.
c Set the minutes by tuning the Multi Jog knob to the right or to
the left.
d
Press Enter.
Result:
OFF TIME
is displayed (instead of the equalizer symbols)
for a few seconds, followed by any switch-off time already
set; you can now set the timer switch-off time.
Set the timer switch-off time.
a
Set the hour by tuning the Multi Jog knob to the right or to the left.
b
Press Enter.
Result: The minutes flash.
c
Set the minutes by tuning the Multi Jog knob to the right or to
the left.
d
Press Enter.
Result:
VOL XX
is displayed, where
XX
corresponds to the
volume already set.
Press Tuning Down and Up to adjust the volume level and press
Enter.
Result: The source to be selected is displayed.
Turn the Multi Jog knob to select the source to be played when the
system switches on.
If you select...
You must also...
TAPE (cassette)
Insert a recorded cassette in one of
the decks before setting the
system to standby.
TUNER (radio)
a Press Enter.
b Select a preset station by tuning
the Multi Jog knob to the right or
to the left.
CD (compact disc)
Load one or more compact discs.
Press Enter to confirm the timer.
Press Standby/On to set the system to standby mode.
Result:
is displayed to the bottom left of the time, indicating that
the timer has been set. The system will switch on and off
automatically at the required times.
Timer Function
7
8
9
5
6
1
2
3
4
After having set the timer, it will start automatically as shown
by the TIMER indication on the display. If you no longer wish
to use the timer, you must cancel it.
You can stop the timer at any time (system on or in standby mode).
To...
Press Timer-On/Off...
Cancel the timer
Once.
Result: is no longer displayed.
Restart the timer
Twice.
Result: is displayed again.
Cancelling the Timer
To set the timer function
You may use Multi Jog or
/
buttons to adjust in step 4,
5, 6, 7.
You can also use Program/Set button on the remote control to
instead Enter button in step 3, 4, 5, 6, 7, 8.
1,9
6
2
6
4,5,7
3,4,5,6,7,8
MAX-ZS720 GB no RDS 18~28 1/25/03 2:00 PM Page 20
