13
Step-by-step installation guide
3
. Remove the screw that holds the blower motor
and carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the blower
unit.
CAUTION
: To avoid breaking or cracking the blower
blade, do not touch the blade. Hold the outer case of the
blower when you pull it out or put it back in place.
4
. Roll the blower unit 90° so that the fan blade
openings are facing toward the front of the
microwave.
Before Roll
After Roll
5
. Place the blower unit back into the opening.
CAUTION
: Do not pull or stretch the blower unit wiring.
Make sure the wires are not pinched.
6
. Remove the metal vent fan cover on the back of the
microwave by sliding it up.
7
. Close the blower door. Slide blower shield onto the
top of the blower door opening.
8
. Secure the blower to the microwave using the blower
retaining screws from Step 1.
Back of
Microwave Oven
Blower Retaining
Screws
Blower Retaining
Screw
B2. INSTALLING THE CHARCOAL FILTER
1
. Remove the screws on the top of the grill using a #1
Phillips screwdriver.
2
. Open the door.
3
. Remove the grill.
• Push the grill left, and then pull the grill straight off.
Charcoal
filter
4
. Install the charocal filter. When properly installed,
the wire mesh of the filter should be visible from the
front.
5
. Reinstall the grille and the screws.
6
. Close the door.
Insert mesh-side up
SMH1927_XAC_DE68-04108D-02_EN+CFR.indb 13
SMH1927_XAC_DE68-04108D-02_EN+CFR.indb 13
2022-01-20 오전 10:26:14
2022-01-20 오전 10:26:14
