6
General information
7
General information
# 1 and #2 Phillips
screwdriver
Pencil
Ruler or tape measure and
straight edge
Carpenter square (optional)
Tin snips (for cutting
damper, if required)
Scissors (to cut
template, if necessary)
Electric drill with
3
/
16
˝, ½˝ and
⅝˝ drill bits
Filler blocks or scrap wood
pieces, if needed for top
cabinet spacing (used on
recessed bottom cabinet
installations only)
Gloves
Saw (saber, hole or
keyhole)
Stud finder or Hammer
(optional)
Safety goggles
Level
Duct and masking tape
TOOLS YOU WILL NEED
NOTES:
• The space between the cabinets must be 30˝ wide and
free of obstructions.
• This microwave oven is for installation over ranges up
to 36˝ wide.
• If you are going to vent your microwave oven to the
outside, see the Hood Exhaust Section for exhaust
duct preparation.
•
If installing the microwave oven beneath smooth
flat cabinets, be careful to follow the instructions
on the top cabinet template for power cord
clearance.
•
maximum cabinet depth above and beside the
unit is 12˝.
•
The dimensions provided are the minimum
required for mounting the microwave oven. Local
codes and the practical use of the range will
likely require you to provide more than the 13.5˝
shown between the range and the bottom of the
microwave.
mOUNTING SPACE
•
If the unit is damaged in shipment,
return the unit to the store in which it was bought for repair or
replacement.
•
If the unit is damaged by the customer,
repair or replacement is the responsibility of the customer.
•
If the unit is damaged by the installer
(if other than the customer), repair or replacement must be made by
arrangement between the customer and installer.
DAmAGE - SHIPmENT/INSTALLATION
HARDWARE PACKET
PART
qUANTITY
Template
INSTALLA
TION
INSTR
UCTIONS
Wood Screws
(¼˝ x 2˝)
1
Template
INSTALLA
TION
INSTR
UCTIONS
Toggle Bolts
(and wing nuts)
(
3
/
16
˝ x 3˝)
2
Template
INSTALLA
TION
INSTR
UCTIONS
Self-aligning
Machine Screws
(¼˝ - 28 x 3 ¼˝)
2
You will find the installation hardware contained in a
packet with the unit. Check to make sure you have all
these parts.
NOTE
: Some extra parts are included.
ADDITIONAL PARTS
PART
qUANTITY
TOP CABINET TEMPLATE
REAR WALL TEMPLATE
Top Cabinet
Template
1
TOP CABINET TEMPLATE
REAR WALL TEMPLATE
Rear Wall Template
1
Installation
Instructions
1
One Touch Easy
Grease Filter
1
(Installed)
Template
INSTALLA
TION
INSTR
UCTIONS
Exhaust adaptor
1
PARTS INCLUDED
SMH1927_XAC_DE68-04108B-01_EN-120725.indd 6
2012-07-25 �� 7:56:31
Summary of Contents for ME21M706BAG/AC
Page 19: ...19 Note SMH1927_XAC_DE68 04108B 01_EN 120725 indd 19 2012 07 25 7 56 39 ...
Page 20: ...Code No DE68 04108B 01 SMH1927_XAC_DE68 04108B 01_EN 120725 indd 20 2012 07 25 7 56 39 ...
Page 39: ...19 Remarque SMH1927_XAC_DE68 04108B 01_CFR_120725 indd 19 2012 07 25 7 57 54 ...
Page 40: ...N de code DE68 04108B 01 SMH1927_XAC_DE68 04108B 01_CFR_120725 indd 20 2012 07 25 7 57 54 ...
