GB
4
To take full advantage of your new MICRO component system,
follow these installation instructions before connecting the unit.
I
nstall the system on a flat, stable surface.
Never place this unit on carpeting.
Never locate this unit in an outdoor area.
Maintain an open space of approximately 4 inches
(10 cm) on the sides and rear of the system, for
ventilation purposes.
Make sure that you have enough room to open the
compact disc compartment easily.
Place the loudspeakers at a reasonable distance on either
side of the system to ensure good stereo sound.
Direct the loudspeakers towards the listening area.
For optimum performance, make sure that both speakers
are placed at an equal distance above the floor.
Insert or replace remote control batteries when you:
Purchase the Micro component system
Find that the remote control is no longer operating
correctly
When replacing the batteries, use a new set of batteries
and never mix alkaline and manganese batteries.
1
Place your thumb on the position marked
on the battery
compartment cover (rear of the remote control) and push the
cover in the direction of the arrow.
2
Insert two AAA, LR03 or equivalent batteries, taking care to
respect the polarities:
+ on the battery a on the remote control
– on the battery against – on the remote control
3
Replace the cover by sliding it back until it clicks into position.
The loudspeaker connector terminals are located on the rear of the
system (red and black tabs).
There are four terminals on the system:
Two for the left speaker (marked L)
Two for the right speaker (marked R)
To achieve the correct sound quality, connect the:
Red wire to the + terminals
Black wire to the - terminals
1
To connect a wire to a terminal, push the tab as far as it will go:
To the right on the system and hold it in position
2
Insert the wire, up to the plastic sheathing, in the hole.
3
Push the tab back:
To the left on the system, release the tab.
Result: The wire is pinched and held firmly in place.
4
Repeat the operation for each wire.
The main lead must be plugged into an appropriate socket.
Before plugging your system into a main socket, you must
check the voltage.
1
Plug the main lead (marked AC CORD on the rear of the
system) into an appropriate socket.
2
Press the On/Standby button to switch your Micro component
system on.
Where to Install Your Micro-Component System
Inserting Remote Control Batteries
Connecting the Loudspeakers
Connecting Your System to the Power Supply
