GB
5
The AM(MW)/LW aerial (for long and medium waves) can be:
Placed on a stable surface
Fixed to the wall (you must first remove the base)
The AM aerial connector terminals are located on the rear of the system
and are marked AM ANT.
To avoid noise interference, check that the loudspeaker wires do
not run close to the aerial wires.
Always keep them at least 2 inches (5 cm) away.
How to connect a COAXIAL TYPE areial.
Connect a 75
Ω
antenna to the FM aerial terminal.
Plug the connector on the FM aerial supplied into the coaxial
socket (75
Ω
) marked FM on the rear of the system.
Follow the instructions given on Page 8 to tune into a radio
station, and determine the best position for the aerial.
If reception is poor, you may need to install an outdoor aerial.
To do so, connect an outdoor FM aerial to the FM socket on the
rear of the system, using a 75
Ω
coaxial cable (not supplied).
Connecting the AM(MW)/LW Aerial
Connecting the FM Aerial
FM
FM
FM AERIAL
(supplied)
75
Ω
COAXIAL CABLE
(not supplied)