GB
9
The AM aerial (for long and medium waves) can be:
Placed on a stable surface
Fixed to the wall (you must first remove the base)
The
AM
aerial connector terminals are located on the rear of the
system and are marked
AM
.
To avoid noise interference, check that the loudspeaker wires do
not run close to the aerial wires.
Always keep them at least 2 inches (5 cm) away.
Connecting the AM (MW)/LW
Aerial
How to connect a COAXIAL TYPE aerial.
Connect a 75
Ω
antenna to the
FM
antenna terminal.
Plug the connector on the
FM
aerial supplied into the coaxial socket
(75
Ω
) marked
FM
on the rear of the system.
Follow the instructions given on
Page 18
to tune into a radio
station, and determine the best position for the aerial.
If reception is poor, you may need to install an outdoor aerial.
To do so, connect an outdoor
FM
aerial to the
FM
socket on the
rear of the system using a 75
Ω
coaxial cable (not supplied).
Connecting the FM Aerial
Using the Audio Cord, Connect the Audio Output Terminals (Left, Right)
of the rear panel with the Audio Input Terminals (Left, Right) of TV.
Using the Video Cord, Connect the Video Output Terminal of the rear
panel with the Video Input Terminal of TV.
Turn on the TV and Select the Video mode by pressing the TV/VIDEO
SELECT button to the VIDEO Position.
Connecting to the Equipment
AUDIO
INPUT
VIDEO
INPUT
R
L
TV
VIDEO
INPUT
AUDIO
INPUT
1
2
3
L
R
()
TV Rear Panel
Connecting the SW Aerial (option)
How to connect a WIRE TYPE aerial.
Spread the
SW
aerial out and attach the ends to a wall, in the position
providing the best reception.
If reception is poor (e.g. distance from transmitter too great, walls blocking
the radio waves, etc.), install an outdoor aerial.
