39
MISCELLANEOUS
40
•
Connect the Microphone.
•
Push the
MIC LEVEL
knob first and then Turn it to adjust the
MIC
level.
•
Press the ECHO button to select ECHO1,ECHO2,and ECHO OFF.
• During using the microphone ,you can press the
REC/PAUSE
button
to record your favorite.
Plug the microphone with a 3.5ø MIC jack
into microphone terminal.
You can connect a set of headphones to your micro component system so that you can listen to music or
radio programmers without disturbing other people in the room.
The earphones must have a 3.5ø jack or an appropriate adapter.
Connecting Headphones/Microphone(option)
Key Control
Press the
KEY CONTROL
button to
adjust the key to your voice. The (-3~+3)7
steps key control you can select .
Result: Each time the
KEY CONTROL #
,
b
button is pressed,
the following appears on the TV screen:
b : Low-Pitched
# : High-Pitched
•
Each time
#
button is pressed, the key is increased, and each time
b
button is pressed, the key is decreased .
•
The function only can available for CD in stop mode when
microphone is connect,it can not available for MP3 .
•
The function for “key control” can not disappear immediately if you
unplugged MIC.
•
The loudspeakers are no longer used to output the sound.
Connect the headphones to the
PHONES
jack on the top panel.
•
Prolonged use of headphones at a high volume may damage
your hearing.
Note
Do not touch the playback side of the disc. Hold
the disc by the edges so that fingerprints will not
get on the surface.
Do not stick paper or tape on the disc.
When you get fingerprints or dirt on the disc, clean it
with a mild detergent diluted in water and wipe with a
soft cloth.
•
When cleaning, wipe gently from the inside to the outside of the disc.
Handling discs
Handling and Storing Discs
Cautions on Handling and Storing Discs
Small scratches on the disc may reduce sound and picture quality or cause breaks in
playback. Be especially careful not to scratch discs when handling them.
•
Condensation may form if warm air comes into contact with cold parts
inside the player. When condensation forms inside the player, the player
may not operate correctly. If this occurs, remove the disc and let the
player stand for 1 or 2 hours with the power on.
Note
•
Check that the tape in the cassette is sufficiently taut.
•
To prevent erasing a cassette that you wish to keep, remove the safety tab on the upper edge of the
cassette. To record a cassette, where the tab has been broken, simply cover the opening with adhesive
tape.
•
When you have finished playing a cassette, always put it back in its case.
•
Store your cassettes in a clean place, out of direct sunlight, where they will not be exposed to high
temperatures.
•
Avoid using 120-minute cassettes as they place unnecessary strain on the tape mechanism.
Precautions When Using Audio Cassettes
MM-X7(31p~64p)-GB-NO 8/11/07 10:43 Page 40
