GB
10
Your system is equipped with a clock which allows you to
turn your system on and off automatically.
You should set the clock:
When you first purchase the micro component system
After a power failure
After unplugging the unit
For each step, you have a few seconds to set the required
options. If you exceed this time, you must start again.
Switch the system on by pressing Standby/On ( ) .
Press Timer/Clock twice.
Result:
CLOCK
is displayed.
Press Program/Set.
Result: The hour flashes.
To...
Press...
Increase the hours
Decrease the hours
When the correct hour is displayed, press Program/Set.
Result: The minutes flash.
To...
Press...
Increase the minutes
Decrease the minutes
When the correct time is displayed, press Program/Set.
Result: The clock starts and is displayed, even when the system is in
standby mode.
You can display the time, even when you are using another
function, by pressing
Timer/Clock
once.
Setting the Clock
1
2
3
4
5
6
7
You can view the various functions available on your system.
Press the Demo button.
Result: The various functions available are listed in turn on the
display.
All these functions are described in detail in this booklet.
For instructions on how to use them, refer to the appropriate
sections.
To cancel this function, press Demo again.
2
1
Viewing the Various Functions on
Your System
Timer
On/Off
EQ/P.Sound
REV.
Mode
CD SYNC.
Display
CD
Repeat
VOL.
Band
+10
Sleep
TAPE
Aux
Timer/
Clock
VOL.
Tune/CD
Mode
Program/
Set
PTY
RDS
4,6
1
3,5,7
4,6
2
Open/Close
Band
CD
TAPE
AUX
TUNER
Volume
Tuning
Mode
Down
Up
Demo/Display
MIC
Rec/Pause
REV.Mode
Sound
Mode
Open/Close
Band
CD
TAPE
AUX
TUNER
TUNER
Volume
Tuning
Mode
Down
Up
Demo
Rec/Pause
REV.Mode
Sound
Mode
