E-
2
Safety Precautions
Read carefully this installation manual before
installation and check if the wired remote control is
installed correctly after installation.
Do not attempt to install or repair this wired remote control
by yourself.
This wired remote control contains no user-serviceable
parts. Always consult authorized service personnel for
repairs.
When moving, consult authorized service personnel for
disconnection and installation of the wired remote control.
Ensure that the wall is strong enough to support the weight
of the wired remote control.
Must install the wired remote control with rated power
supply.
The wired remote control must be installed according to
the national electrical rules by an installation specialist.
If you wish to uninstall the wired remote control, consult an
authorized installation center.
WARNING
CAUTION
Do not use inflammable gases near the wired remote
control.
Do not install the wired remote control in a location where
it will come into contact with combustible gases, machine
oil, sulphide gas, etc.
Avoid locations where acid/alkali solution or special spray
is used.
Choose a location that is dry and sunny, but not exposed to
direct sunlight. Suitable temperature is between
0°C and 39°C.
Do not spill water into the wired remote control.
Do not apply tensile strength to the cable to avoid cable
damage.
Do not press the buttons with a sharp object.
Do not connect the power cable to the control terminal.
If the wired remote control is installed in a hospital or other
special places, it should not affect other electronic devices.
This installation manual describes how to install the wired remote control.
For installation of other optional accessories, refer to the appropriate installation manual.
MWR-SH00_IM_E_28133.indd 2
2007-06-21 ｿﾀﾀ・10:48:35
