7
European Telecommunication
Information (for products fitted with
EU-approved modems)
Marking by the symbol
indicates
compliance of this equipment to the
Radio and Telecom Terminal Equipment
Directive 1999/5/EC. Such marking is
indicative that this equipment meets or
exceeds the following technical standards:
CTR 1 - Attachment requirements for
pan-European approval for connection to
the analogue Public Switched Telephone
Networks (PSTNs) of TE (excluding TE
supporting voice telephony services) in
which network addressing, if provided, is
by means of Dual Tone Multi-Frequency
(DTMF) signaling.
Although this equipment can use
either loop disconnect (pulse) or
DTMF (tone) signaling, only the
performance of the DTMF signaling
is subject to regulatory requirements
for correct operation.
It is therefore strongly recommended
that the equipment is set to use
DTMF signaling for access to public
or private emergency services.
DTMF signaling also provides faster
call setup.
This equipment has been approved to
Council Decision 8/8/EEC - “CTR
1” for Pan-European single terminal
connection to the Public Switched
Telephone Network (PSTN).
However, due to differences between
the individual PSTNs provided in
different countries, the approval does
not, of itself, give an unconditional
assurance of successful operation on
every PSTN termination point. In the
event of problems, you should contact
manufacturer Technical Support.
Summary of Contents for NC10 Series
Page 1: ...User Guide ...
