27
4. Troubleshooting
4-1 Failure Display Codes
There is a error code and two kinds of error codes. Possible error codes
during use can be checked before service.
1. Touch ‘
Clock
¶NH\
2. Touch a number ‘
¶NH\
3. Touch ‘
Oven Start / Set
¶NH\
4. Touch ‘
Favorite Cook
¶DQGµ
Wake-Up
¶NH\VDWWKHVDPHWLPHIRU
3seconds. Error codes are displayed.
+
5. Touch number ‘
0
¶NH\WKHODVWHUURUFRGHVFDQEHFKHFNHG
But, if the oven turns off, the stored error codes are deleted.
6. Touch ‘
Oven Off
¶NH\WRUHWXUQWRQRUPDOGLVSOD\PRGH
4. Troubleshooting
Safety error
Failure code
CAUSE
SOLUTION
E-24
Oven heating over
1. Disconnect power. Open the back cover.Disconnect sensor
KDUQHVVIURPFRQWURO0HDVXUHVHQVRUUHVLVWDQFHȍDWWKH
URRPWHPSHUDWXUHĺ,IWKHUHDUHDQ\SUREOHPVUHSODFHRYHQ
sensor.
2. Check the broil, bake and convection heater.Check the resistance
of the each heater.
3. Check whether DLB of Main PCB, Broil, Bake and Convection
heater relay are being worked normally.
4. Check whether there is any disconnection of harness which is
linked with main PCB on sub PCB.
5. Check the resistance of oven sensor connector on main PCB.
1RUPDOȍ
6. It will display “E-24” after beeping 10 times Bzlong, if temperature
is more than 600
ሥ
(316
ఁ
) during oven is working excluding the
case of self-cleaning.
7. Please make sure through the method of 4-1 on 29 page, if
those series of working for informing error take long time or not
functioned.”
E-0E
Door locking error
1. Disconnect power. Open the back cover. Check wether harness
has been connected with door lock switch and motor.
2.
&RQ¿UPZKHWKHUUHVLVWDQFHYDOXHRIGRRUORFNPRWRULVWREH
normal one or not.
3. With operating door lockout, measure a voltage of connector on
harness which is linked with door lock motor.
(Normal Voltage : AC 120V)
4. Check whether door locking switch is being worked normally.
