English 67
Maint
aining y
our applianc
e
Potential for permanent damage to
the glass surface
• Sugary spillovers (such as jellies, fudge,
candy, syrups) or melted plastics can cause
pitting of the surface of your cooktop.
This is not covered under the warranty.
You should clean the spill while it is still
hot. Take special care when removing hot
substances. Refer to the following section.
• When using a scraper, be sure it is new
and the razor blade is still sharp. Do not
use a dull or nicked blade.
Cleaning sugary spills and melted
plastic
1.
Turn off all surface units. Remove hot
pans.
2.
Wearing an oven mitt, use a single-edge
razor-blade scraper to move the spill to a
cool area of the cooktop. Remove the spill
with paper towels.
3.
Any remaining spillover should be left
until the surface of the cooktop has
cooled.
4.
Don’t use the surface units again until
all of the residue has been completely
removed.
NOTE
If pitting or indentations in the glass surface
have already occurred, the cooktop glass
will have to be replaced. In this case, service
will be necessary.
Cleaning the cooktop seal
To clean the seal around the edges of the
glass, lay a wet cloth on it for a few minutes,
then wipe clean with a nonabrasive cleaner.
NE59J7850WS_AA_DG68-XXXXXX_EN.indd 67
2015-01-21 11:24:12