English 21
C
ookt
op c
ooking
Location of the radiant surface elements and controls
The radiant control knobs operate the radiant surface elements on the cooktop as
shown below.
01
06
07
02
05
04
03
01 Left Front:
Double Burner
6”/9”
02 Left Rear:
Single Burner
6”
03 Right Front:
Triple Burner
6”/9”/12”
04 Right Rear:
Single Burner
6”
05 Warming center
06 Hot surface
indicator
07 Cooktop on
indicator
About the radiant surface elements
The temperature rises gradually and evenly. As the temperature rises, the radiant
element will glow red. To maintain the selected setting, the element will cycle
on and off. The heating element retains enough heat to provide a uniform and
consistent heat during the off cycle. For efficient cooking, turn off the element
several minutes before cooking is complete. This will allow residual heat to
complete the cooking process.
NOTE
Radiant elements have a limiter that allows the element to cycle ON and OFF, even
at the HI setting. This helps to prevent damage to the ceramic cooktop. Cycling at
the HI setting is normal and can occur if the cookware is too small for the radiant
element or if the cookware bottom is not flat.
Summary of Contents for NE59N6650SS
