12
English
Range Hood Use and Care
Range Hood Use and Care
Range Hood Description
1
2
3
4
1. LED lamps
2. Filter handle
3. Filter
4. Control
Range Hood Controls
A
B
C
D
E
A. Light Power
B. Blower Off button
C. Low Speed
D. Medium Speed
E. Maximum Speed
Operating the light
1.
The Light On/Off button (A) controls both lights. Press once for ON
and again for OFF.
Operating the blower
1.
To turn the blower On press speed 1 button (C), control the blower
speed and sound level with 2 (D) and 3 (E) buttons.
Press the blower Off button to turn the blower off.
Cleaning
Exterior surfaces:
To avoid damage to the exterior surface, do not use steel wool or soap-
filled scouring pads. Do not use chlorine based cleaners. Rub in the
direction of the grain line to avoid scratching the surface.
•
For a thorough cleaning, use Stainless Steel Cleaner and Polish.
•
For everyday cleaning, use a mild liquid detergent and water. Dry
thoroughly.
•
For a quick cleaning, wipe with a damp soft cloth or nonabrasive
sponge, then rinse with clean water and wipe dry.
NOTE
Always wipe dry to avoid water marks.
Metal or Charcoal Grease Filter
1.
Pull the filter latch toward the back of the range hood and using a
Torx T10 adapter, remove the screw from the filter retainer.
2. For vented installations:
Wash the metal filter as needed in a dish
-
washer or hot detergent solution.
3. For non-vented (recirculating) installations:
Replace the metal fil
-
ter with a charcoal filter. The charcoal filter is not washable. It should
last up to 6 months with normal use. Dispose of old charcoal filter.
To replace the filter
1.
Place the back edge of the filter into the chanel at the rear of the
hood.
2.
Pull the filter latch toward the back of the range hood and push the
front of the filter up into place.
3.
Replace the screw and
release the filter latch.
Replacing the LED Lamp
LED lights are replaceable by a service technician only.
See the contact information in the Warranty section.
