English
9
Mark Hole Locations
1.
Determine and clearly mark a vertical centerline on the wall and
cabinet bottom.
A
To wire through top:
1.
Mark a line distance (A) from the right of the centerline on the under-
side of the wall. Mark the point on this line that is 2” (5.08 cm) from
the underside of the cabinet. Drill a
7
⁄
8
″
(2.2 cm) diameter hole (B)
through the rear wall at this point.
A
A
B
2”
(5.08 cm)
A
A. 8 2/5" (21.3cm)
To wire through wall:
1.
Mark a line distance (A) from the right of the centerline on the under-
side of the wall. Mark the point on this line that is
7
⁄
8
″
(2.2 cm) from
the underside of the cabinet. Drill a
7
⁄
8
″
(2.2 cm) diameter hole (B)
through the rear wall at this point.
B
A
7⁄8”
(2.2 cm)
A. 8 2/5" (21.3cm)
Mark and Cut Vent Opening
For a non-vented (recirculating)
installation: skip "Mark and Cut Vent
Opening" step.
For 3¼" x 10" (8.3 x 25.4 cm) Rectangular Vent System
Roof Venting
To make a 4” x 10½” (10.16 cm x 26.7 cm) rectangular cutout on the
underside of cabinet top and bottom:
1.
Mark lines 1½” (3.95 cm) and 4
4
⁄
5
” (12.25 cm) from the back wall on
the centerline of the underside of cabinet. Mark lines 5¼” (13.3 cm)
to the right and left of the centerline on the underside of cabinet.
Cabinet cutouts
5
1
/
4
*1
1
/
2
(3.95 cm)
(13.3 cm)
5
1
/
4
(13.3 cm)
*From wall, not cabinet frame
*4
4
/
5
(12.25 cm)
Centerline
2.
Use saber or keyhole saw to cut a rectangular opening for vent.
3.
Repeat steps 1-3 for the underside of the top of the cabinet.
Wall Venting
To make a 3½” x 10½” (8.9 cm x 26.7 cm) rectangle in the wall:
1.
Make 2 lines by measuring
4.2
⁄
10
” (1.1 cm) and 3
.7
⁄
10
” (9.4 cm) down
from underside of cabinet and mark on the centerline on the back
wall.
2.
Mark lines 5¼” (13.3 cm) to the right and left of the centerline on the
wall.
3
7
⁄
10
”
(9.4 cm)
4.2
⁄
10
”
(1.1 cm)
5
1
/
4
”
(13.3 cm)
5
1
/
4
”
(13.3 cm)
Centerline
3.
Use saber or keyhole saw to cut a rectangular opening in the wall for
the vent.
For 7" (17.8 cm) Round Vent System (Roof Venting)
To make a circular vent opening on the underside of the cabinet top:
1.
Mark a centerline on the underside of the top of cabinet.
2.
Mark a line
5” (12.8 cm)
from the back wall on the underside of the
top of cabinet.
3.
Use a compass or a circle template to draw a circle with a diameter of
7½” (19 cm).
Installation Instructions
Installation Instructions
