27
Operation
T1. ON/OFF Suction motor:
When hood is on, it switches off at any speed by pressing button
T1
.
When the hood is off, it switches on at Speed 1 by pressing button
T1
.
T2. Speed decrease
Press
"T2"
button to decrease the speed from 4 (Boost) to 1.
T3. Speed increase
Press the button (hood is ON) to increase the the speed of the motor from speed 1
to the Boost speed (timed).
Speed 1 LED
L1
Speed 2 LED
L2
Speed 3 LED
L3
Boost (timed) LED
L4
flashing
Note:
Speed 4 (Boost timed) remains activated for 5 minutes, after which the hood
sets speed 2 automatically
T4. Speed timing
Speed timing is activated by pressing
T4
button, when timing is up the hood
switches off.
Timing is divided as follows:
Speed 1 - 20 minutes (LED
L1
)
Speed 2 - 15 minutes (LED
L2
)
Speed 3 - 10 minutes (LED
L3
)
Boost - 5 minuts (LED
L4
flashing)
During timed operation press
T2
button and the hood quits the timed mode and
decreases the speed.
Press
T3
button and the hood quits the timed mode and increases the speed.
Press
T4
button and the hood quits the timed mode maintaining the set speed.
T5. Lights ON/OFFF
Press the Light button and the lamps will turn on
Press the Light button again and the lamps will turn off.
Filter saturation signal button
–
Control and Configuration:
Grease filter signal
After 40 hours of operation LED
L1
flashes.
When such signal appears, carry out grease filter maintenance.
To reset the signal, keep
T1
button pressed for 3”. (hood is ON).
LED
L1
stops flashing before the hood goes back to OFF.
Charcoal filter signal
After 160 hours of operation LED
L2
flashes.
When such signal appears, carry out charcoal filter maintenance.
To reset the signal, keep
T1
button pressed for 5”.
(hood is ON).
LED
L2
stops flashing before the hood goes back to OFF.
In case of contemporaneous signalling of both filters, LEDs
L1
and
L2
flash jointly.
To reset, carry out the procedure described above for 2 times.
The first time it resets the charcoal filter signal, the second time it resets the grease
filter signal.
The charcoal filter signal is not active in the standard mode.
In case the hood is used in filter version it is necessary to enable the charcoal filter
signal.
Activating charcoal filter signal:
Set the hood to OFF and press
T2+T3
button for 3”.
Once the button has been pressed, LED
L1
flashes for 1".
LEDs
L1
and
L2
flash until the hood gives out a "BEEP", as confirmed activation, and
goes back to OFF.
Deactivating charcoal filter signal:
Set the hood to OFF and press
T2+T3
button for 3”.
Once the buttons have been pressed, the LEDs
L1+L2
flashes for 1".
The hood gives out a "BEEP" and LED
L2
switches off.
LED
L1
flash until the hood gives out a "BEEP", as confirmed disactivation, and goes
back to OFF.
