70
71
Chapter 3.
Using the computer
5
When the system reboots, press the corresponding key(s) by
following the onscreen instructions.
6
When the computer restarts automatically and the Samsung
logo screen appears, press the
F2
key repeatedly.
7
Select the
Security > TPM Configuration > Change TPM
Status
item and set the item to
Enable and Activate
.
Aptio Setup Utility
TPM Configuration
TPM Support
Change TPM Status
Security Chip State
Security
[Enabled]
[
No Change
]
Disabled and Deactivated
No Change
Clear
Enable and Activate
Disable and Deactivate
8
Press the
F10
key to save the changes.
9
When the system reboots, press the corresponding key(s) by
following the onscreen instructions.
10
Press the
F10
key to save the changes. The computer
automatically restarts. Initialization of the TPM chip has been
completed. Now, install the TPM program and register the
TPM program.
Installing the TPM program
You can install the TPM program as follows. Install the program
according to the procedures below.
This program is only provided for models with Recovery and
the TPM function.
Method 1
1
Run
Recovery
and click on
System Software
.
- If your computer does not boot up or if
System Software
does not display in the
Recovery
program, use
Method 2
to install the TPM program.
2
Click on
System Software
Installation.
3
The
SW Update
program will be launched.
Select
TPM Host SW
and click
Install Now
.
If the system software media is supplied with the product,
you can install the program by using the system software
media (only when supplied.)
4
After the installation, if you click
OK
, the computer restarts.
Using the TPM Security Device
(Optional)
Summary of Contents for NP900X3D-A02US
Page 1: ...User Guide ...
