English 73
Maint
aining y
our applianc
e
5.
Repeat for the right (front and back)
slide mechanism of the rack.
6.
Open and close the rack several times
to distribute the lubricant.
7.
Replace the cap on the lubricant and
shake it again. Turn the rack over and
repeat steps 3, 4, 5, and 6.
8.
Close the rack, turn the rack right-
side-up, and then place in oven. See
Installing the gliding rack
on page
60
.
NOTE
•
Do not spray the gliding rack with
cooking spray or other lubricant sprays.
Oven door
Don’t hand
clean the
oven door
gasket.
You may
hand clean
the door.
•
Use soap and water to thoroughly
clean the top, sides, and front of the
oven door. Rinse well. You may use a
glass cleaner on the outside glass of
the oven door. DO NOT immerse the
door in water.
DO NOT spray or allow
water or the glass cleaner to enter the
door vents.
DO NOT use oven cleaners,
cleaning powders, or any harsh
abrasive cleaning materials on the
outside of the oven door.
•
DO NOT clean the oven door gasket.
The oven door gasket is made of a
woven material which is essential for a
good seal. Care should be taken not to
rub, damage, or remove this gasket.
Removing the oven door (Lower oven only)
CAUTION
•
The door is very heavy. Be careful when removing and lifting the door.
•
Do not lift the door by the handle.
Use two hands to remove an oven door.
WARNING
You can't remove the upper oven door for safety reason.
A
A.
Wire Harness
1.
Prior to removing the oven door,
prepare a surface where you will place
it. This surface should be flat and
covered with a soft blanket. You can
also use the corner posts from your
packaging material.
2.
Disconnect the LED light's Wire Harness
from the bottom right of the door.
NQ70M7770D_AA_DE68-04447A-00_EN.indd 73
1/19/2017 12:01:18 PM