18 English
Ins
tallation r
equir
ement
s
Installation requirements
Electrical requirements
WARNING
To reduce the risk of fire, electric shock, or personal injury:
All ranges
•
Do not use an extension cord or adapter plug with this range.
•
This range must be properly grounded.
•
Check with a qualified electrician if you are in doubt as to whether your range is
properly grounded.
•
Do not modify the plug provided with your range—if it doesn’t fit the outlet, have
a proper outlet installed by a qualified electrician.
•
All wiring and grounding must be done in accordance with local codes or, in the
absence of local codes, with the National Electrical Code, ANSI/NFPA No. 70–
Latest Revision (for the U.S.) or the Canadian Electrical Code CSA C22.1–Latest
Revisions and local codes and ordinances.
•
Wiring diagram is located on the back of the range. (Inside of the cover back wire)
•
This range is equipped with an electronic ignition system that will not operate if
plugged into an outlet that is not properly polarized.
Gas models
•
All gas models are equipped with a power cord with an equipment-grounding
conductor and a grounding plug.
•
A 120 Volt, 60 Hz, AC, approved electrical service with 20 amp circuit breaker or
time-delay fuse is required for all U.S. and Canadian models.
•
Check for ¾ in (1.9 cm) UL-listed strain relief where the power cord comes out of
the range cabinet.
•
Do not reuse a power supply cord from an old range or other appliance.
•
The power cord electric supply wiring must be retained at the range cabinet with
a suitable UL-listed strain relief.
•
A time-delay fuse or circuit breaker is also recommended.
Grounding
•
All ranges must be grounded for personal safety.
•
All gas models have a power cord with an equipment-grounding conductor and a
grounding plug.
•
The plug must be firmly plugged into a three-prong outlet that is properly
installed and grounded in accordance with all local codes and ordinances. In
the event of a malfunction or breakdown, grounding will decrease the risk of
electrical shock by providing a path for the electric current.
•
Do not use a damaged power plug or loose wall outlet.
•
Do not use an extension cord or adapter with this appliance.
•
Do not, under any circumstances, cut, modify, remove, or otherwise defeat the
grounding (third) prong from the power cord. If the plug and the outlet do not
match or you have any doubt, have a qualified electrician install the proper
outlet.
The customer should have the wall receptacle and circuit checked by a qualified
electrician to make sure the receptacle is properly grounded.
Ground Fault Circuit Interrupters (GFCIs) are not required or recommended for
gas range receptacles.
• NEVER
connect ground wire to plastic plumbing lines, gas lines, or water pipes.
CAUTION
Failure to follow these instructions can result in death, fire, or electrical shock.
Usage situations where appliance power cord will be disconnected frequently
Do not use an adapter plug in these situations because disconnecting of the
power cord places undue strain on the adapter and leads to eventual failure
of the adapter ground terminal. Where a standard two-prong wall receptacle
is encountered, it is the personal responsibility and obligation of the customer
to have it replaced with a three-prong (grounding) receptacle by a qualified
electrician before using the appliance.
01. DG68-01600A-00_IM_NSG6DG8700SRAA_EN_231102.indd 18
01. DG68-01600A-00_IM_NSG6DG8700SRAA_EN_231102.indd 18
2023-11-06 오전 11:47:48
2023-11-06 오전 11:47:48
