Samsung NV660, User Manual

English - 10

installation

Safety instructions for the installation

This oven may be installed only by an approved electrician. The installer is responsible for 

connecting the appliance to the main supply, while observing the relevant safety regulations.

• 

Ensure protection from live parts when installing the oven.

Power connection

If the appliance is not connected to the mains with a plug, a multi-pole isolator 

switch (with at least 3 mm contact spacing) must be provided in order to satisfy 

safety regulations. The power cable (H05 RR-F or H05 VV-F, min., 2.5 mm²) 

must be of sufficient length to be connected to the oven, even if the oven 

stands on the floor in front of its built-in cabinet. Open the rear connection cover 

of the oven with a screwdriver and loosen the screws of the cable clamp before 

you connect the power lines to the relevant connection terminals. The oven is 

earthed via the (   )-terminal. The yellow and green cable (earth connection) 

must be connected first and be longer than the others. If the oven is connected 

to the mains with a plug, this plug must remain accessible after the oven is 

installed. Samsung will take no responsibility for accidents that originate from a 

missing or faulty earth connection.

WARNING: 

Do not allow the connecting cable to become trapped during installation, and 

prevent it coming into contact with hot parts of the oven.

Installation in the cabinet

With built-in furniture, plastic surfaces and adhesive for the oven should be resistant to 90 °C inside of 

the furniture and to 75 °C for adjacent furniture. Samsung will take no responsibility for damage of plastic 

surfaces or adhesive from the heat.

1

545

560

572

595

595

21

2

Lower 

element

Airflow through the ventilation gap

Top 

element

There should be a ventilation gap 

in the base of the kitchen cabinet 

where the oven is to be placed. For 

ventilation, a gap of about 50 mm 

should be left between the lower shelf 

and the supporting wall. If the oven is 

to be installed below a hob, the hob’s 

installation instructions should be 

followed.

3

Lower element

min. 600

min. 50

min. 560

min. 550

4

50

Top element

min. 550

min. 590 

-max. 600

min. 560

5

Push the appliance completely into the cabinet and fix the oven firmly on both sides using 2 screws. Make 

sure that a gap of at least 5 mm should be left between the appliance and the adjacent cabinet. 
After installation, remove the vinyl protective film, tape, paper and accessories from the door and inside 

of oven. Before uninstalling the oven from the furniture, disconnect the oven from the power supply and 

release the 2 screws on the both sides of the oven.

WARNING: 

The built-in furniture must have a minimum ventilation gap for Air-flow as shown 

on picture. Do not cover this hole with strips of wood, for this is used to provide ventilation.
The front exterior of the oven such as handle is different model by model. But the size of the 

oven in the picture is same.

BROWN 

or BLACK

BLUE or 

WHITE

YELLOW 

and GREEN

NV660_HC_DG68-00593B-00_EN.indd   10

2014-05-12   �� 3:05:38