Call Waiting / Camp-on
Busy stations are notified that a call is waiting (camped-on) when they receive a tone. The tone
will be repeated at a programmable interval. Keysets receive an off-hook ring signal through the
speaker and single line stations receive a tone in the handset. The volume of the camp-on tone
can be set by the station user.
See: MMC 50 System Timers
(default OFF HOOK RING INTERVAL: 015 sec)
Centrex / PBX Use
Centrex and PBX lines can be installed instead of C.O trunks. Feature codes and the hook flash
command can be stored under one-touch buttons. Toll restriction programming ignores PBX or
Centrex access codes so toll calls can be controlled when using these services.
See: MMC 62 PBX Access Code
Chain Dialling
Station users may manually dial additional digits following a speed dial call or chain together as
many speed dial numbers as required.
See: MMC 16 Key Extender
MMC 17 Station Speed Dial
MMC 71 System Key Programming
MMC 62 Station Key Programming
Class Of Service
System programming allows stations to be assigned one of six outgoing call restriction level.
Refer to TOLL RESTRICTION feature.
Conference
Any combination of up to five (5) parties (stations or outside lines) can be joined together in an
add-on conference. A station user may set up a conference with two or more outside lines and
then exit the conference leaving the outside lines connected in an unsupervised (trunk to trunk)
conference. Parties may be eliminated or added after a conference has been established.
Database Printout
Customer data can be printed out. This printout can be directed to a PC and can be done on-site.
The database may be printed in its entirety or by specific MMC; for instance, directory names or
speed dial lists.
See: MMC 80 I/O Parameter
3 - 5
NX-828
HYBRID KEY SYSTEM
FEATURES
Summary of Contents for NX-828
