English 47
Maint
enanc
e
NOTE
Make sure all surface burners are off while
the oven is performing a self cleaning
cycle. Self-clean will not operate if a surface
burner is on.
To delay starting a self-cleaning cycle
3
2
4
1.
Repeat steps 1 and 2 on the previous page.
2.
Press the
Delay Start
pad. The oven door locks.
3.
Set the time you want the oven to start self-cleaning using the number pad.
4.
Press the
START/SET
pad. The oven will start self-cleaning at your specified
time.
To cancel the self-cleaning cycle
You may find it necessary to stop or interrupt a self-cleaning cycle due to smoke
in the oven. To turn off the self-cleaning cycle, press the
OFF/CLEAR
pad. The
cycle turns off, but the door remains locked and the Lock icon blinks until the oven
temperature falls below 400 °F (200 °C).
After self-cleaning
•
The door stays locked until the internal oven temperature falls below 400 °F.
•
When the oven has cooled down, wipe the oven surfaces with a cloth to remove
ash residue.
•
Stubborn stains can be removed using a steel-wool pad. Lime deposits can be
removed using a vinegar-soaking cloth.
•
If you are not satisfied with the cleaning results, repeat the cycle. “HOT” appears
on the display until the oven cools down. Wait until the message disappears, and
then start a new cycle.
•
The cooling fan automatically runs for certain amount of time after self-cleaning.
CAUTION
Do not attempt to open the oven door immediately after the self-cleaning cycle is
complete. The oven is still very hot when the door unlocks. Escaping hot air and/or
steam could burn you.
Replacing the oven light
Oven light
The oven light is a standard 40-watt appliance bulb. It comes on when you open
the oven door.
Remove
Glass bulb cover
Bulb
Replace
1.
Turn off the oven.
2.
Make sure the oven and oven light are
cool.
3.
Open the door, and remove the glass
cover by turning it counterclockwise.
4.
Remove the oven light from the socket
by turning it counterclockwise.
5.
Insert a new 40-watt appliance bulb into
the socket, and then turn it clockwise to
tighten.
6.
Reinsert the glass cover, and then turn it
clockwise to tighten.
CAUTION
To prevent electric shock, make sure the oven is turned off and cool before
replacing the oven light.
NOTES
•
The oven light does not operate during the self-cleaning cycle.
•
Remove the racks if they prevent you from accessing the oven light.
Summary of Contents for NX58K9850S series
