English 39
Maint
enanc
e
CAUTION
•
The starter electrodes are not removable. Do not attempt to remove them by
force.
•
Make sure all burner components (heads and caps) are reinstalled properly.
When installed properly, they are stable and rest flat.
•
To avoid chipping, do not bang grates and caps against each other or hard
surfaces such as cast iron cookware.
Self-cleaning
This self-cleaning oven uses high temperatures (well above cooking temperatures)
to burn off leftover grease and residue completely or reduce them to a finely
powdered ash that you can wipe away with a damp cloth.
CAUTION
•
Do not leave small children unattended near the range during the self-
cleaning cycle. The outside surfaces of the range can get extremely hot.
•
Some birds are extremely sensitive to fumes from a self-cleaning gas oven.
Relocate birds to a well-ventilated room away from the range.
•
Do not line the oven, oven racks, or oven bottom with aluminum foil. Doing
so will result in poor heat distribution, produce poor baking results, and cause
permanent damage to the oven interior. The aluminum foil will melt onto and
adhere to the interior oven surfaces.
•
Do not force the oven door open during the self-cleaning cycle. This will
damage the automatic door-locking system. The door automatically locks
when the self-cleaning cycle is started and stays locked until the cycle is
cancelled and the oven temperature is below 400 °F.
•
Use caution when opening the oven door after the self-cleaning cycle. The
gas oven will still be VERY HOT and hot air and steam might escape when the
door is open.
•
Wipe off any excess spillage before using the self-cleaning operation.
•
Do not use oven cleaners. Commercial oven cleaners or oven liners should
NEVER be used in or around any part of the oven. Residue from oven cleaners
will damage the inside of the oven during a self-cleaning operation.
Burner grates and components
Turn off all surface burners, and make sure they have all cooled down.
1
3
2
1.
Remove the burner grates.
2.
Remove the burner caps from the
burner heads.
3.
Remove the burner heads from the
valve manifolds to reveal the starter
electrodes.
4.
Clean all removable grates and burner
components in warm, soapy water. Do
not use steel-wool pads or abrasive
cleaners.
5.
Rinse and dry grates and burner
components thoroughly.
7
8
6
Top
Bottom
6.
Return the burner heads to their
positions on top of the manifold
valves. Make sure a starter electrode
is inserted through the hole in each
burner head.
7.
Return the burner caps to their
positions on top of burner heads. To
ensure proper and safe operation, make
sure the burner caps lie flat on top of
the burner heads.
8.
Re-install the burner grates in their
respective positions.
9.
Turn on each burner and check if it
operates properly. After verifying that
a burner operates normally, turn it off.
NX5000M_NX58M6650WS_AA_DG68-00993A-00_EN+MES+CFR.indb 39
6/29/2017 1:09:31 PM
