42 English
Maint
enanc
e
Maintenance
Warming / Storage drawer
Warming drawer (NX58M6650W* Only)
1.
Slide open the drawer until it stops.
2.
Locate the roller guide clips on either
side. Using both hands, pull down the
left clip while lifting the right clip, and
then remove the drawer.
3.
Clean the drawer in warm, soapy water
using a cloth or soft brush. Then, rinse
and dry it thoroughly.
4.
Put the drawer in the roller guides on
either side, and then snap the clips into
place.
Storage drawer (NX58M6630S* Only)
1.
Slide open the drawer until it stops.
2.
Pull the drawer with lifting it for
removal.
3.
Clean the drawer in warm, soapy water
using a cloth or soft brush. Then, rinse
and dry it thoroughly.
4.
Push in the drawer while slightly lifting
the front to close it.
To re-install the oven door
1.
Firmly grasp both sides of the door at the top.
2.
With the door at the same angle as the removal position, slide the indentation
of the hinge arm into the bottom edge of the hinge slot. The notch in the
hinge arm must be fully inserted into the bottom of the slot.
Hinge arm
Bottom
edge of
slot
Indentation
3.
Open the door fully. If the door will not open fully, the indentation is not
inserted correctly in the bottom edge of the slot.
4.
Push the hinge locks up against the front frame of the oven cavity into the
locked position.
Hinge lock
Locked position
Unlocked position
5.
Close the oven door.
NX5000M_NX58M6650WS_AA_DG68-00993A-01_EN+MES+CFR.indb 42
2017-10-18 12:10:31
Summary of Contents for NX58M6650WS/AA
Page 50: ...50 English Memo NX5000M_NX58M6650WS_AA_DG68 00993A 01_EN MES CFR indb 50 2017 10 18 12 10 32 ...
Page 51: ...English 51 Memo NX5000M_NX58M6650WS_AA_DG68 00993A 01_EN MES CFR indb 51 2017 10 18 12 10 32 ...
Page 103: ...Español 51 Notas NX5000M_NX58M6650WS_AA_DG68 00993A 01_EN MES CFR indb 51 2017 10 18 12 10 48 ...