48
3. Disassembly and Reassembly
3-27 Replacing the HOT SURFACE IGNITOR (HSI) of the BURNER BAKE, NOZZLE
BAKE-BURNER, and HOLDER BAKE-BURNER
WARNING
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range . Replace all panels before operating the range . Failure to do
so can result in death or electrical shock .
WARNING
EXPLOSION, FIRE, AND ASPHYXIATION HAZARD
Shut off the gas supply to the range before servicing. Check all gas lines and fittings for leaks before
operating the range . Replace all panels before operating the range . Failure to do so can result in death or
personal injury from explosion, fire, or asphyxiation.
CAUTION
When you work on the gas range, be careful when handling sheet metal parts . Sharp edges may be present,
and you can cut yourself if you are not careful .
Parts
Explanation Photo
Explanation
Hot Surface
Ignitor (HSI)
HSI
1.
To replace the burner bake HSI, Remove 2 screws
assembled to HSI .
Nozzle Bake
-Burner
HOLDER
NOZZLE
1.
To replace the nozzle bake-burner, Remove the
gas orifice with a 9/32-inch
socket wrench .
Holder
Bake-Burner
1 .
To remove the holder-bake burner, Remove 2
screws supporting the holder-bake burner to the
rear of the oven .
2 .
When the service is complete, reverse the order
to install Burner bake, HSI, Nozzle, Holder bake-
burner .
NOTE
The
oven burner flames can be adjusted by
loosening the locking screw and opening or
closing the air shutter at the base of the oven
burner .
