English 45
Maint
enanc
e
NOTE
Make sure all surface burners are off while
the oven is performing a self cleaning
cycle. Self-clean will not operate if a surface
burner is on.
To delay starting a self-cleaning cycle
1.
Repeat steps 1 and 2 on the previous page.
2.
Select
Set Delay Start
.
3.
Set the time you want the oven to start self-cleaning using the dial knob.
4.
Tap
START
. The oven will start self-cleaning at your specified time.
To cancel the self-cleaning cycle
You may find it necessary to stop or interrupt a self-cleaning cycle due to smoke in
the oven. To turn off the self-cleaning cycle, tap
OFF
. The cycle turns off, but the door
remains locked and the Lock icon blinks until the oven temperature falls below 400 °F
(200 °C).
After self-cleaning
•
The door stays locked until the internal oven temperature falls below 400 °F.
•
When the oven has cooled down, wipe the oven surfaces with a cloth to remove ash residue.
•
Stubborn stains can be removed using a steel-wool pad. Lime deposits can be
removed using a vinegar-soaking cloth.
•
If you are not satisfied with the cleaning results, repeat the cycle. Wait until the oven
cools down, and then start a new cycle.
•
The cooling fan automatically runs for certain amount of time after self-cleaning.
•
Self-cleaning does not operate within 2 hours after running the self-cleaning cycle.
CAUTION
Do not attempt to open the oven door immediately after the self-cleaning cycle is
complete. The oven is still very hot when the door unlocks. Escaping hot air or steam
could burn you.
NX60BB8715QNAP_AP_DG68-01493A-01.indb 45
NX60BB8715QNAP_AP_DG68-01493A-01.indb 45
2023-01-20 오전 11:17:50
2023-01-20 오전 11:17:50
