English 49
Tr
ouble
shoo
ting
Problem
Cause
Action
The burners do not
burn evenly.
Surface burner
components and caps are
not assembled correctly
and level.
See page
The surface burners are
dirty.
Clean the surface burner
components.
(See page
.)
Very large or
yellow surface
burner flames.
The wrong burner orifice
is installed.
Check the burner orifice size.
Contact your installer if you
have the wrong orifice (LP
gas instead of natural gas or
natural gas instead of LP gas).
Surface burners
light but oven
burners do not
light.
The oven door lock is
turned on.
The display will show the Lock
icon. Hold the oven door open
and Tap and hold
START
for
3 seconds. The oven will beep
and the Lock icon will turn off.
The Gas Pressure
Regulator shut off switch
is in the off position.
Call a qualified service
technician.
Oven
Problem
Cause
Action
The oven control
beeps and displays
an information
code.
There may be an issue
with your oven. See the
“Information codes” chart
on page
.
Tap
OFF
, and then restart the
oven.
If the problem persists,
disconnect all power to the
range for at least 30 seconds
and then reconnect the power.
If this does not solve the
problem, call for service.
The oven will not
turn on.
The oven is not
completely plugged into
the electrical outlet.
Make sure the electrical plug
is fully inserted into a live,
properly grounded outlet.
A fuse in your home
may be blown or the
circuit breaker may have
tripped.
Replace the fuse or reset the
circuit breaker.
The oven
temperature is too
hot or cold.
The oven thermostat
needs adjustment.
See page
NX60BB8715QNAP_AP_DG68-01493A-01.indb 49
NX60BB8715QNAP_AP_DG68-01493A-01.indb 49
2023-01-20 오전 11:17:51
2023-01-20 오전 11:17:51
