14 English
Ins
tallation r
equir
ement
s
Installation requirements
CAUTION
Do NOT lift or handle the unit by the cooktop frame.
Fig. 1
1.
The counter top around the cut-out
should be flat and leveled (See hatched
area on Fig. 1).
2.
Before installing the unit, measure
the heights of the two cabinet sides
(C1~C4), front and back (See Fig. 1)
from the floor to the top of the counter.
3.
Level the range using the four leveling
legs so that the height from the floor
to the underside of the cooktop frame
is greater than the tallest cabinet
measurement
by at least 1/16"
.
4.
Slide the unit into the cabinet (
DO NOT
PUSH THE UNIT HARD
). Make sure the
center of the unit aligns with the center
of the cabinet cut-out.
5.
The metal flange under each side of
the cooktop
MUST
be placed over the
cabinet countertop for proper unit
support. The cooktop should
NOT
rest
directly on the countertop or else it
could cause damage to the cooktop
voiding the warranty. Level the unit if
needed.
IMPORTANT:
MAKE SURE
the unit is supported by the
leveling legs and
NOT
by the cooktop itself.
To avoid breakage
CAUTION
Please
DO NOT
push the unit strongly when
you install. These actions can cause the
damage to the unit.
Please
DO NOT
push the burner knobs when
installing the range.
(Grasp the L/R door area to push the unit.)
Summary of Contents for NY58J9850WS/AA
