English 11
Ins
talling the hob
Installing the hob
WARNING
Be sure the new appliance is installed and grounded only by qualified personnel.
Please observe this instruction. The warranty will not cover any damage that may occur as a
result of improper installation.
Technical data is provided at the end of this manual.
Safety instructions for the installer
•
A device must be provided in the electrical
installation that allows the appliance to be
disconnected from the mains at all poles
with a contact opening width of at least 3
mm. Suitable isolation devices include line
protecting cut - outs, fuses (screw type
fuses are to be removed from the holder),
earth leakage trips and contactors.
•
With respect to fire protection, this
appliance corresponds to EN 60335 - 2 -
6. This type of appliance may be installed
with a high cupboard or wall on one side.
•
The installation must guarantee shock
protection.
•
The kitchen unit in which the appliance
is fitted must satisfy the stability
requirements of DIN 68930.
•
For protection against moisture, all cut
surfaces are to be sealed with a suitable
sealant.
•
On tiled work surfaces, the joints in
the area where the hob sits must be
completely filled with grout.
•
On natural, artificial stone, or ceramic tops,
the snap action springs must be bonded
in place with a suitable artificial resin or
mixed adhesive.
•
Ensure that the seal is correctly seated
against the work surface without any
gaps. Additional silicon sealant must not
be applied; this would make removal more
difficult when servicing.
•
The hob must be pressed out from below
when removed.
•
A board can be installed underneath the
hob.
•
The ventilation gap between the worktop
and front of the unit underneath it must
not be covered.
NZ84J9770EK_EE_DG68-00632A-02_SV+NO+FI+DA+EN.indb 11
2016-12-06 12:29:41
Summary of Contents for NZ84J9770EK
