OfficeServ 100 Installation Manual/Ed.00
© SAMSUNG Electronics Co., Ltd.
7-7
7.5 SMDR (Station Message Detail Recording)
Use MISC 1 (2): DCS Compact-II or iDCS 100 System
To receive an SMDR printout, connect a customer-provided printer to one of the serial
interface connectors on a MISC 1(2) card(See Figure 7.5). SIO2 defaults as SMDR.
Figure 7.5 PIN Connections for MISC Card to Printer
Use a pin to pin RS232C cable. Only pins 2, 3 and 5 are required(See Figure 7.5).
When the printer or optional call accounting device needs to be more then 15 feet away
from the KSU, use shielded computer cable. Attach a male DB9 connector to the MISC end
and then attach one that matches the requirements of the call accounting device or printer
to the other end. This cable must not exceed 300 feet.
Use MMC 725 to set SMDR print options and MMC 804 to set the transmission
parameters and the MISC port.
Use MCP1: OfficeServ 100 System
To receive SMDR printout, traffic or alarm reports connect a customer-provided printer or
PC to one of the RS232C DB9 connectors or by LAN interface on the MCP1 card.
Use a pin to pin RS232C cable. Only pins 2, 3 and 5 are required(See Figure 7.5).
MISC card(DB9)
RX 2
TX 3
GND 5
Printer(DB25)
2 TX
3 RX
7 GND
TxD
RxD
GND
