CHAPTER 2.
Ошибка
!
Стиль
не
определен
.
2-74
© SAMSUNG Electronics Co., Ltd.
[300] CUSTOMER ON/OFF PER STATION
Allows the following features to be enabled on a per-station basis.
No
Option
Default
Description
00
ACCESS DIAL
ON
Determines whether a user can select a trunk or trunk
group by dialling its directory number(DN).
This selection should be turned to off when using LCR.
01
MICROPHONE
ON
Allows all 12 and 24 button phones to be used in the
speakerphone mode.
02
OFF-HOOK RING ON
Will allow a short burst of ring tone to indicate another call.
03
SMDR PRINT
ON
When the station is set for no Trunk Line calls to and
from this station, the station will not print on SMDR.
This includes transferred calls or calls picked up from
hold or park.
04
TGR ADV.TONE
ON
When this feature is set to ON, a warning tone will be
heard each time LCR advances to the next route.
05
VMAA FORWARD ON
This feature selects whether Trunk Line calls can be
forwarded to voice mail. When ON, Permits forward to
voice mail. When OFF, No forward to voice mail.
07
NGT PASSCODE
ON
When ON, the steps verifying the RING PLAN
passcode will be added in Ring Plan change.
08
INTRCOM SMDR
OFF
When the station is set to OFF, the station will not print
intercom calls on SMDR.
09
FWD DLY USE
OFF
When the station is set to ON, if the station has no
answer forward number without no answer forward set
then a call both ringing original extension and no
answer forward number when a incoming call is
directed to the station and the station does not answer
until no answer forward time.
11
FORWARD OVRD OFF
When the station is set to ON, if the station call to
forwarded station, the call will not forward.
12
RECL TO OPER
OFF
When the station is set to ON, if the station transfer a
call and the destination doesn’t answer, the call will be
recall to operator instead of the station.
13
SLT LP OPEN
OFF
When the normal phone is set to ON, if the station
receives real disconnect signal instead of busy tone or
error tone. In case of VMAA ports or DATA RING ports
are not reference this option, this type SLI ports are
always receives real disconnect signal.
15
CID TO SLT
OFF
When RCM2 card is installed and this option is set to
ON, the system will provide the CID signal to the SLT.
