OfficeServ 500 Programming Guide
© SAMSUNG Electronics Co., Ltd.
2-129
[416] ASSIGN E & M/DID RINGDOWN
This MMC defines which ring destination table an E & M or DID trunk will follow
for incoming calls. There are three options for each trunk as defined below.
No
Option
Description
0
FOLLOW INCOM DGT
When a trunk is set to this option calls will ring at the
destination that matches the digits received from the Trunk line.
1
FOLLOW DID TRANS
When a trunk is set to this option calls will ring at the
destination defined in MMC 714 that matches the digits
received from the TRUNK LINE
2
FOLLOW TRK RING
If this option is selected, press the Right Soft button and
‘
NO.
RCV DIGIT
’
: will appear on the display. Here is where the
number of incoming digits from Trunk Line must be entered
(0 through 4). When a trunk is set to this option calls will ring at
the destination defined in MMC 406 for that trunk. If the
destination defined in MMC 406 is a VMAA port or group then
the system will repeat the digits received from the CO to the
port when it answers.
CONDITIONS
R2MFC trunk lines only support the ‘FOLLOW INCOM DGT’ and ‘FOLLOW DID
TRANS’ options.
DEFAULT DATA
FOLLOW INCOMING DIGIT
ACTION DISPLAY
1) Press Transfer button and enter 416.
Display shows:
[701] EM/DD RING
FOLLOW INCOM DGT
2) Enter desired trunk number.(e.g., 705)
OR
[705] EM/DD RING
FOLLOW INCOM DGT
Press Volume button to make selection and
press Right Soft button to move cursor.
OR
Press ANS/RLS button to select all trunks.
[ALL] EM/DD RING
FOLLOW INCOM DGT
3) Dial
option
number.(0~2)
OR.
[705] EM/DD RING
NO. RCV DIGIT:00
Press Volume button to make selection and press
Right Soft button to return step 2.
If the FOLLOW TRK RING is selected, the
LCD display shows step 4.
