CHAPTER 2.
Ошибка
!
Стиль
не
определен
.
2-190
© SAMSUNG Electronics Co., Ltd.
(Continued)
No
Option
Description
2
OVERFLOW
This is the timer value that will cause unanswered calls to a group to
begin also ringing the NEXT PORT(see below) after this timer has
elapsed. If set to 000, no overflow will take place.
3 GROUP
TRANSFER
This is a timer that will determine how long Trunk Line calls transferred
to the group will ring at the group before recalling. If set to 000, no recall
will take place.
4
NEXT PORT
This is the station or group number that callers will also ring at if the
OVERFLOW feature has been programmed. The OVERFLOW
DESTINATION can be defined as:
1 COMMON BELL There are up to 3 Common bells available on L
system and 1 on M system. Because there is a common bell port on
each MISC card.
2 RING OVER PAGE The ROP port can be defined as the NEXT port.
3 STATION OR STATION GROUP. Any station or station group can be
defined as the NEXT port.
5
MEMBER
List all members that are to be in the group. Up to 48 members for the
system are allowed in each group, but stations can be assigned to
multiple station groups
6
NEXT HUNT
The length of time a call will ring at a station before it hunts to the next
group member.
7
GROUP BUSY
When this option is set to ON, a busy signal will be sent to the caller if
all group members are busy. When this option is set to OFF, the ring
back tone is sent to the caller even if all group members are busy.
Obviously UCD is an exception to this rule. This option only works when
MMC 210 SGR INC BUSY is set to OFF. When MMC 210 SGR INC
BUSY is set to ON, all station groups will follow this setting.
8
GRP AUTOANS
When this option is set to ON, a group call follows auto answer option
also.
Calls to a group
Calls to a group do not follow the call forwarding instructions of any stations in the
group.
CONDITIONS
y
A station can be assigned to all station groups. A station group can normally
accommodate up to 48 members, but only up to 32 members if the RING MODE is
‘UNCONDITIONAL’.
y
To enable off-hook ring for calls incoming to busy members, set the OFFHOOK RING
of MMC 300 CUSTOMER ON/OFF PER STATION OFFHOOK RING to ‘ON’.
Even in this case, however, the off-hook ring is enabled only when the RING MODE is
‘UNCONDITIONAL’.
