CHAPTER 2.
Ошибка
!
Стиль
не
определен
.
2-230
© SAMSUNG Electronics Co., Ltd.
[709] TOLL PASS CODE/SPECIAL CODE TABLE
This MMC provides a means to program three trunk code tables as described below.
No
Special Code
Description
0
PBX CODE
This table contains up to five entries and is used to identify the
trunk access codes needed for toll restriction to be properly
applied when the system is used either behind a PBX or with
CENTREX-supplied dial tone. Toll restriction will only be applied
on trunks flagged as PBX in MMC 401 if a trunk access code
entered in this table is dialed. Toll restriction will be applied to
the digits following the trunk access code.
1
SPECIAL CODE
This table identifies to the system dialling rules the special
feature codes used to activate central office custom calling
features such as CID Block and call waiting disable. The special
feature codes can be used on a per call basis without affecting
LCR or toll restriction programming. There is a maximum of
ten(10) entries available each of which may be up to four digits
long.
2
TOLL OVERRIDE
This table of eight entries is used to identify to the system
numbers that will bypass all dialling restrictions. This bypass
includes Toll restriction, Trunk access and forced authorization
or account codes. Each entry in the table can be up to 14 digits
long.
3
OVER USE TRK GRP
This entry designates the trunk group that toll override calls will
access.
CONDITIONS
NONE
DEFAULT DATA
NONE
